Most of the oil presses do not feed in the new equipment. This is because the new machine's squeezing screw is not worn well, and the squeezing head is smashed back and the material is not smooth. The oil of the screw press is propelled by the snail. If a certain part is not smooth, the fuel advancement speed will be slow. The treatment method is to extract the screw and use a polishing machine to smooth the non-smooth portion.

The two reasons are that the oil line is blocked. If the oil line is blocked, the oil can not flow out in time, it will flow in the squeeze, the space will become smaller and the oil will not go smoothly. The treatment method is to clean the oil line, that is, in the spiral oil When the machine is working, use a hammer to shake off the blockage of the oil line.

The three reasons are that the temperature of the screw press is too high. The treatment method is to return the machine with a cold cake after processing one pot, and turn off the electric heating.

The four reasons are that the oil is fry. If the oil is too low, the oil will stick to the screw and the oil will not go down.

Another reason is the wear at the interface between the rear bracket and the press bar. In this case, one of the extrusion heads will shift, and there will be no gaps at all, and the oil behind will not enter.

Regarding the related issues of the new oil press, you can pay attention to Shengshi Gaohong! !