The more cherished, the use of the oil press can not escape this truth. Explain some of the little knowledge of the life of the oil press.

The working principle of the oil press is nothing more than the use of high pressure propulsion, high pressure extrusion and other principles to work. Therefore, the wear of the components is a concern of the mechanical equipment during use. In the normal use process, good operating habits should be developed. Before each work, the machine should be preheated, idling, and gradually increasing the material. The squeezing suddenly heats up or suddenly heats up and suddenly increases the pressure. After each operation, the machine is reversed or the raw materials are cleaned, and the components such as the squeeze bar and the oil pan are cleaned.

Regular maintenance and close cooperation of various parts of the oil press, service life.

1. Regularly check the oil press motor and heating coil power interface, switchboard, etc., pay attention to electricity.

2. When the cake is out of the cake or the oil is not normal, the screw shaft should be pulled out to check the wear of the screw, the strip and the cake. The worn parts should be replaced in time.

3. The oil press should check the lubrication after every 50 hours of operation. The inside of the reducer should not be short of oil. The vacuum pump must not be short of oil, and the vacuum pump is locked. The screw shaft adjustment screw inner bearing should be filled with grease from the adjustment screw hole every shift, dry grinding is strictly prohibited.